[Technical Notice] Audio Setting Failure on GV-FER5702 V1.06
Posted: May 26th, 2023, 1:37 pm
Article ID: GV3-23-05-25-A
Release Date: May 25, 2023
Applied to
GV-FER5702 (firmware V1.06)
Symptom
After GV-FER5702 is upgraded to V1.06, the system fails to apply Audio setting changes with a pop-up message displaying “Setting the parameter(s) failed.”
Solution
To successfully apply the Audio settings, restore to default settings on GV-FER5702 Web interface and try changing the Audio settings again.
Release Date: May 25, 2023
Applied to
GV-FER5702 (firmware V1.06)
Symptom
After GV-FER5702 is upgraded to V1.06, the system fails to apply Audio setting changes with a pop-up message displaying “Setting the parameter(s) failed.”
- 01.png (141.03 KiB) Viewed 9810 times
To successfully apply the Audio settings, restore to default settings on GV-FER5702 Web interface and try changing the Audio settings again.
- On the Web interface of GV-FER5702, select Setup > System > Maintenance, and select Default in the Config Management section. The camera should restart after successfully restoring to default settings.
- 02.jpg (75.7 KiB) Viewed 9810 times
- On the Audio setting page, set the desired parameters and click Save.