[ Control Center ] Multicam v8.7, Control Center v3.3, Dewarp Matrix Full , Black screen - 20160926
Posted: September 26th, 2016, 11:06 am
Issue:
After Multicam v8.7 disconnecting from CC v3.3, it is required to press F2/F4 button ( Previous/next cameras ) GV-in GV-Joystick many times in order to switch current PTZ camera to the others in CC Matrix
You can see user must now press those F2 and F4 buttons many many times to switch current PTZ camera. Sometimes 3-4 times and sometimes even 10 times !!! The more disconnections between CC and NVR the more times user must press those buttons !!!
Patch / Procedure ( Patch Name: ControlCenter_V3.3.1.0.i ) :
http://ftp.geovision.tw/FTP/DerekHo/Con ... .1.0.i.zip
1. Turn off Control center, Matrix, mcamctrl and other GV-related programs
2. Unzip the patch file
3. Copy and paste the files into the location below C:\Control Center
- PtzStick_Parser.dll
- VersionInfo_ControlCenterV3310i_160922.ini
4. Run Control Center again to see how everything goes.
* Note that above patch is based on Control Center v3.3
Reference:
Re: [ Polvision - 201609146003 ] After Multicam v8.7 disconnecting from CC v3.3, it is required to press F2/F4 GV-Joystick buttons many times to switch current PTZ camera in CC Matrix
After Multicam v8.7 disconnecting from CC v3.3, it is required to press F2/F4 button ( Previous/next cameras ) GV-in GV-Joystick many times in order to switch current PTZ camera to the others in CC Matrix
You can see user must now press those F2 and F4 buttons many many times to switch current PTZ camera. Sometimes 3-4 times and sometimes even 10 times !!! The more disconnections between CC and NVR the more times user must press those buttons !!!
Patch / Procedure ( Patch Name: ControlCenter_V3.3.1.0.i ) :
http://ftp.geovision.tw/FTP/DerekHo/Con ... .1.0.i.zip
1. Turn off Control center, Matrix, mcamctrl and other GV-related programs
2. Unzip the patch file
3. Copy and paste the files into the location below C:\Control Center
- PtzStick_Parser.dll
- VersionInfo_ControlCenterV3310i_160922.ini
4. Run Control Center again to see how everything goes.
* Note that above patch is based on Control Center v3.3
Reference:
Re: [ Polvision - 201609146003 ] After Multicam v8.7 disconnecting from CC v3.3, it is required to press F2/F4 GV-Joystick buttons many times to switch current PTZ camera in CC Matrix