[ DVR/NVR ] CGI commands for getting info about motion detection via PUSH or PULL methods from GV-NVR - 20150714
Posted: July 14th, 2015, 2:17 pm
Applied to:
GV-NVR
Question:
Is there any CGI command that can be used for getting motion detection via PUSH or PULL methods from GV-NVR?
Answer:
It is only able to get the mentioned info through Live OCX (SDK).
There is no support for getting motion detection by CGI commands.
Reference:
[ EVS - 201506256002 ] CGI commands for getting info about motion detection via PUSH or PULL methods from GV-NVR
GV-NVR
Question:
Is there any CGI command that can be used for getting motion detection via PUSH or PULL methods from GV-NVR?
Answer:
It is only able to get the mentioned info through Live OCX (SDK).
There is no support for getting motion detection by CGI commands.
Reference:
[ EVS - 201506256002 ] CGI commands for getting info about motion detection via PUSH or PULL methods from GV-NVR