[ AS Hardware ] Why input status led is on on AS controller? - 20150505
Posted: May 5th, 2015, 10:54 am
Please see in the highlighted area below that the dip
switch adjusting N/O N/C status are enabled.
The led will turn on if the status of the input is on,
and when the dip switches are adjusted to NC, the
led light will turn on.
Therefore, this is normal condition.
switch adjusting N/O N/C status are enabled.
The led will turn on if the status of the input is on,
and when the dip switches are adjusted to NC, the
led light will turn on.
Therefore, this is normal condition.
- temp20150505b.jpg (80.17 KiB) Viewed 1935 times