[ AS Hardware ] GV-Reader unable to read 3rd party card - 20230927
Posted: September 27th, 2023, 6:04 pm
Issue:
GV-Reader unable to read 3rd party card
Solution:
If you are using third-party cards or key fobs, you must set the reader to read UID
To set the connected reader to read UID (Unique Identifier)
Please follow the followings:
1. Open Web interface of your controller.
Since multiple readers can connect to GV-AS Controller using one RS-485 interface,
you need to specify which door each reader controls.
On the controller’s Web interface, click Extended Reader. This dialog box appears.
2.In the GV-Reader/CR420/GF1921/GF1922 section, select the RS485 checkbox next to
the ID number, and type the Serial Number which can be found on the rear panel of the
reader. The ID number is assigned to the reader.
3.Select a door/gate for the reader from the Function drop-down list.
Read Mode
In the Read Mode Section
Set "Read UID" from the drop down. UID (Unique Identifier)
Click Submit.
Note:
1. When you click Submit on the Extended Reader page of GV-AS1010 / 210 / 2110 /
2120 / 410 / 4110 / 810 / 8110, GV-AS1620, or GV-CS1320, all readers connected
through RS-485 interface will reboot.
2. GID format is only supported by GV-RK1352 / GV-R1352 / GV-DFR1352 (Rev. B)
V1.2 or later.
3. If you are using third-party cards or key fobs, you must set the reader to read UID.
Reference: GV-Card_Reader_User_Manual.pdf
GV-Reader unable to read 3rd party card
Solution:
If you are using third-party cards or key fobs, you must set the reader to read UID
To set the connected reader to read UID (Unique Identifier)
Please follow the followings:
1. Open Web interface of your controller.
Since multiple readers can connect to GV-AS Controller using one RS-485 interface,
you need to specify which door each reader controls.
On the controller’s Web interface, click Extended Reader. This dialog box appears.
- AS2010.png (70.31 KiB) Viewed 33908 times
2.In the GV-Reader/CR420/GF1921/GF1922 section, select the RS485 checkbox next to
the ID number, and type the Serial Number which can be found on the rear panel of the
reader. The ID number is assigned to the reader.
- GV-R1352.png (44.77 KiB) Viewed 33908 times
Read Mode
In the Read Mode Section
Set "Read UID" from the drop down. UID (Unique Identifier)
- Read GID.png (40.96 KiB) Viewed 33908 times
Note:
1. When you click Submit on the Extended Reader page of GV-AS1010 / 210 / 2110 /
2120 / 410 / 4110 / 810 / 8110, GV-AS1620, or GV-CS1320, all readers connected
through RS-485 interface will reboot.
2. GID format is only supported by GV-RK1352 / GV-R1352 / GV-DFR1352 (Rev. B)
V1.2 or later.
3. If you are using third-party cards or key fobs, you must set the reader to read UID.
Reference: GV-Card_Reader_User_Manual.pdf