[ DVR/NVR ] Connection error when adding AXIS camera into software? - 20180222
Posted: February 22nd, 2018, 10:23 am
Q. When trying to add AXIS camera into DVR/NVR software, I received a connection error message?
A.
ONVIF and VAPIX are enabled by default.
If the product is first accessed via VAPIX (typically via the products web interface),
ONVIF will automatically be disabled.
If ONVIF shall be used in the system:
Access the camera via ONVIF after factory default (before it's accessed via VAPIX).
Enable the parameter Webservices in Advanced > Plain config > Webservices
This is valid for products running firmware versions prior to 5.40.
For products running firmware version 5.40 and higher, ONVIF access is disabled as soon as the root's password is configured and to enable it an ONVIF user needs to be added under System Options > Security > ONVIF.
A.
ONVIF and VAPIX are enabled by default.
If the product is first accessed via VAPIX (typically via the products web interface),
ONVIF will automatically be disabled.
If ONVIF shall be used in the system:
Access the camera via ONVIF after factory default (before it's accessed via VAPIX).
Enable the parameter Webservices in Advanced > Plain config > Webservices
- WebService.jpg (171.78 KiB) Viewed 1718 times
For products running firmware version 5.40 and higher, ONVIF access is disabled as soon as the root's password is configured and to enable it an ONVIF user needs to be added under System Options > Security > ONVIF.