[ AS Hardware ] EV48 is configured for GID reader mode, but after power cycling, it reverts to UID mode - 20171031
Posted: November 1st, 2017, 11:20 am
Issue:
With the GV-RK1352 (RS485) connected to GV-EV48 v1.41 2016-919, the system successfully reads and collects card numbers in GID format upon card swiping. However, after the controller is rebooted, it inexplicably reverts to automatically reading card numbers in UID format.
Response:
The most recent camera firmware update with the correction is now accessible on the GV website below.
https://www.geovision.com.tw/download/p ... ol%20Panel
Reference:
201708232005
With the GV-RK1352 (RS485) connected to GV-EV48 v1.41 2016-919, the system successfully reads and collects card numbers in GID format upon card swiping. However, after the controller is rebooted, it inexplicably reverts to automatically reading card numbers in UID format.
Response:
The most recent camera firmware update with the correction is now accessible on the GV website below.
https://www.geovision.com.tw/download/p ... ol%20Panel
Reference:
201708232005