[ VMS ] VMS v16.11, Camera DB storage path, convert NVR DB to VMS DB - 20171031
Posted: October 31st, 2017, 9:17 pm
Issue:
Camera DB storage path will be restored to default when upgrade from GV-NVR to GV-VMS v16.11
Solution:
Please refer to the steps below to apply the patch. After applying the patch, NVR (any version) DB can be converted into VMS v16.11 DB directly.
Patch / Procedure ( GV-VMSV16.11.0.005.zip ):
1. Uninstall GV-NVR.
2. Install GV-VMS V16.11, and click "No" when the following message pop-up. Please do not run GV-VMS in this moment.
3. Install the patch in the attachment.
4. Unzip the file, GV-VMSV16.11.0.005.zip, and install "GV-VMSV16.11.0.005.exe"
5. Run "RepairLog500.exe" under GV-VMS folder
6. Mark up all the cameras in the list as the screenshot below and click OK.
7. A message will pop-up, click "Yes" to convert the database.
8. Well done!
NOTE:This patch is only for VMS v16.11.
Reference:
JVS Joy Chou, 2017/08/22, NVR database轉換為VMS database
Camera DB storage path will be restored to default when upgrade from GV-NVR to GV-VMS v16.11
Solution:
Please refer to the steps below to apply the patch. After applying the patch, NVR (any version) DB can be converted into VMS v16.11 DB directly.
Patch / Procedure ( GV-VMSV16.11.0.005.zip ):
1. Uninstall GV-NVR.
2. Install GV-VMS V16.11, and click "No" when the following message pop-up. Please do not run GV-VMS in this moment.
- 16.11.0.005.png (26.49 KiB) Viewed 3065 times
4. Unzip the file, GV-VMSV16.11.0.005.zip, and install "GV-VMSV16.11.0.005.exe"
5. Run "RepairLog500.exe" under GV-VMS folder
6. Mark up all the cameras in the list as the screenshot below and click OK.
- 16.11.0.005-1.png (79.26 KiB) Viewed 3065 times
- 16.11.0.005-3.png (23.27 KiB) Viewed 3065 times
- 16.11.0.005-2.png (45.19 KiB) Viewed 3065 times
Reference:
JVS Joy Chou, 2017/08/22, NVR database轉換為VMS database