[ Utility ] How to run the BurnInTest - 20170731
Posted: July 31st, 2017, 3:17 pm
Question:
How to run the BurnInTest
Answer:
Download link:
https://www.passmark.com/products/bit.htm
BurnIn Test has different versions. GV-FAE use Standard version because it offers more than 15 minutes testing.
Note: 30-day trial version doesn't support 15 minutes testing
A: To show up the configuration interface.
B: Normally, FAE will setup 48 hours (2880 minutes) running.
The test option is CPU, RAM, 2D/3D Graphic, Disk, Network and you can see below.
If the result shows "Pass", it means the tested PC passes the test
If the result shows "Fail", it means the tested PC fails the test
How to run the BurnInTest
Answer:
Download link:
https://www.passmark.com/products/bit.htm
BurnIn Test has different versions. GV-FAE use Standard version because it offers more than 15 minutes testing.
Note: 30-day trial version doesn't support 15 minutes testing
- 31.jpg (67.93 KiB) Viewed 3526 times
B: Normally, FAE will setup 48 hours (2880 minutes) running.
The test option is CPU, RAM, 2D/3D Graphic, Disk, Network and you can see below.
- 32.jpg (159.18 KiB) Viewed 3526 times
- 33.jpg (190.23 KiB) Viewed 3526 times
- 34.jpg (281 KiB) Viewed 3526 times