[ Video Server ] When multiple analog cameras connected to VS2400 the PTZ function was lost - 20170628
Posted: June 28th, 2017, 10:36 am
Applies to:
VS2400
Issue:
When VS2400 connect to multiple analog cameras by means of RS485 interface, it seemed only one camera has PTZ function, whereas the rest of the port lost the PTZ function.
Solution:
First they need to update the VS2400 to firmware 1.03.
Then customer could use the “Coaxial Cable Control PTZ” method to connect the multiple analog cameras, as illustrated below:
Choose PTZ Name as HD-TVI/AHD Coaxial and leave Baud Rate and Address as blank.
Then for the Coaxial Setting section, choose HIKVISION DES-2AE5223TI-A, other than that, you can just simply choose Generic. Note that while PTZ is used under this method, PTZ button can not be hold, it can only be clicked.
Reference:
RE: [201611018002] VS2400 connect to multiple analog cameras losing PTZ functions.
VS2400
Issue:
When VS2400 connect to multiple analog cameras by means of RS485 interface, it seemed only one camera has PTZ function, whereas the rest of the port lost the PTZ function.
Solution:
First they need to update the VS2400 to firmware 1.03.
Then customer could use the “Coaxial Cable Control PTZ” method to connect the multiple analog cameras, as illustrated below:
- Pic1.png (222.25 KiB) Viewed 3442 times
Then for the Coaxial Setting section, choose HIKVISION DES-2AE5223TI-A, other than that, you can just simply choose Generic. Note that while PTZ is used under this method, PTZ button can not be hold, it can only be clicked.
Reference:
RE: [201611018002] VS2400 connect to multiple analog cameras losing PTZ functions.