[Technical Notice] How to Apply GV-Control Center V3 Settings to V4

Central Monitoring Station technical notice
Post Reply
amber
Posts: 67
Joined: September 24th, 2021, 5:06 pm

[Technical Notice] How to Apply GV-Control Center V3 Settings to V4

Unread post by amber »

Article ID: GV6-24-04-18-A
Release Date: April 18, 2024

Applied to
  • GV-Control Center V3.8.0
  • GV-Control Center V4.2.0 ~ V4.2.1
Introduction
When upgrading GV-Control Center V3.8.0 to GV-Control Center V4.2.0 ~ V4.2.1, different measures are required to apply older version settings to the new version. Follow the instructions below.

Note: For GV-Control Center V3.7.0 or earlier, it is required to upgrade to GV-Control Center V3.8.0 before starting the following configurations.

System settings and Matrix View settings
  1. On the live view window of GV-Control Center V3, click the Configure button, and select Export Data to export the system setting file (.ccb).
  2. Optionally set a password for importing the file later.
  3. On the live view window of GV-Control Center V4, click the Configure button, and select Import Data.
  4. On the popup dialog box, type the password (if configured at Step 2).
    01.png
    01.png (11.26 KiB) Viewed 3223 times
  5. After the data import is completed, GV-Control Center V4 will restart, and the login dialog box will appear.
  6. Click Cancel on the dialog box to close GV-Control Center V4.
  7. Install the Matrix Inverter tool here and save it at the same path of GV-Control Center V4.
  8. Right-click on the Matrix Inverter tool and select Run as administrator.
  9. On the popup window, click the … button to locate the GV-Control Center V3 system setting file (.ccb) and click Start.
    02.png
    02.png (4.11 KiB) Viewed 3223 times
  10. On the popup dialog box, type the password (if configured at Step 2), and select OK.
    03.png
    03.png (6.53 KiB) Viewed 3223 times
Note: The Matrix View function is only applicable to GV-Control Center V3. The settings will be converted to the Layout settings on GV-Control Center V4.

E-MAp Editor settings
  1. On GV-Control Center V3 E-Map Editor window, select File > Save to file….
  2. On GV-Control Center V4 E-Map Editor window, select File > Load from file… to import the exported file.
Note: With the exported GV-Control Center V3 system setting file, the E-Map Editor setting file, and the Matrix Inverter tool, this method is applicable either when upgrading to GV-Control Center V4 or when applying the settings to a fresh install of GV-Control Center V4.

Application Position settings
Currently, the Application Position settings cannot be directly exported / imported, so a manual setup on GV-Control Center V4 is required. See Chapter 8 Multi Monitors Applications in GV-Control Center User’s Manual V4 for details.

Note: All settings will be imported when upgrading from GV-Control Center V3 to the upcoming GV-Control Center V4 version (after V4.2.1).
Top
Post Reply

Return to “CMS”